Confirmation Driving Pattern
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON and turn the Techstream on.
- Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
- Turn the ignition switch off.
- Turn the ignition switch to ON (READY), and then after 20 seconds turn the ignition switch off and wait for 20 seconds. [A]NOTE:
Make sure that the shift lever is in P.
- Repeat [A] 3 times. [B]
- Enter the following menus: Powertrain / HV / Trouble Codes. [C]
- Check that permanent DTCs are cleared.
HINT:
- If a permanent DTC is output, the system is malfunctioning.
- If no permanent DTC is output, the system is normal.