LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2012 >> Highlander Hybrid >> Repair and Diagnosis >> Hybrid/Electric Powertrain >> Testing and Diagnosis >> Hybrid Vehicle Control System (Diagnostic Codes (P0A7A-122 - P0AC0-817) (Hybrid) >> Hybrid Control System >> DTC P0A7A-522: Generator Inverter Performance >> Confirmation Driving Pattern

Confirmation Driving Pattern

  1. Connect the Techstream to the DLC3.
  2. Turn the ignition switch to ON and turn the Techstream on.
  3. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
  4. Turn the ignition switch off.
  5. Turn the ignition switch to ON (READY) and turn the Techstream on.
  6. With the vehicle stopped and the shift lever in P, move the shift lever to N for 10 seconds and then move the shift lever back to P.
    NOTE:

    Do not leave the vehicle for an extended time with the shift lever in N.

  7. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
  8. Check that permanent DTCs are cleared.
  9. If the permanent DTCs are not cleared, perform the universal trip, and then check for permanent DTCs again.

    HINT: 

    • If a permanent DTC is output, the system is malfunctioning.
    • If no permanent DTC is output, the system is normal.
scientia non olet · About LEMON Manuals