LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2012 >> Highlander Hybrid >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Parking Brake (Service Information) (Hybrid) >> Parking Brake Switch >> Installation >> Installation

Parking Brake Switch: Installation: Installation

  1. INSTALL PARKING BRAKE SWITCH ASSEMBLY 
    1. Install the parking brake switch assembly to the parking brake control pedal assembly with the screw.

      Torque: 0.9 N*m (9 kgf*cm, 8 in.*lbf) 

  2. INSTALL PARKING BRAKE CONTROL PEDAL ASSEMBLY 
    1. Temporarily install the parking brake control pedal assembly with the 3 nuts.
    2. Tighten the 3 nuts.

      Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf) 

    3. Connect the parking brake switch connector.
  3. CONNECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY 

    Refer to INSTALLATION - Step 11

  4. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY 

    Refer to INSTALLATION

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .

  6. INSTALL BATTERY SERVICE HOLE COVER ASSEMBLY  . Refer to INSTALLATION - Step 119
  7. INSTALL DECK BOARD ASSEMBLY  . Refer to INSTALLATION - Step 120
  8. INSPECT BRAKE WARNING LIGHT  . Refer to ADJUSTMENT - Step 3
  9. INSPECT SRS WARNING LIGHT 

    Refer to DIAGNOSIS SYSTEM

scientia non olet · About LEMON Manuals