Door LOCK Position Circuit: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Main Body / Data List.
5. Read the display on the Techstream.
   MAIN BODY:
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   D-Door Lock Pos SW	Driver side door lock position switch signal / ON or OFF	ON: Driver side door unlocked OFF: Driver side door locked	-
   P-Door Lock Pos SW	Front passenger side door lock position switch signal / ON or OFF	ON: Front passenger side door unlocked OFF: Front passenger side locked	-
   RR-Door Lock Pos SW	Rear door lock position switch RH signal / ON or OFF	ON: Rear door RH unlocked OFF: Rear door RH locked	-
   RL-Door Lock Pos SW	Rear door lock position switch LH signal / ON or OFF	ON: Rear door LH unlocked OFF: Rear door LH locked	-

   OK

   Normal conditions listed above are displayed.

   HINT: 

   If the normal conditions listed above are not displayed, perform the troubleshooting of the power door lock control system.

NG → See step   3 

OK → See step   2