Tachometer Malfunction: Procedure

1. Check if a CAN communication DTC is output.Refer to DIAGNOSIS SYSTEM .
   RESULT
   
   

   Result	Proceed to
   CAN communication DTC is not output	A
   CAN communication DTC is output	B

B → See step   5 

A: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Combination Meter / Active Test.
5. According to the display on the Techstream, perform the Active Test.
   COMBINATION METER
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   TachoMeter Operation	Tachometer	0/1000/2000/3000/4000/5000/ 6000/7000 rpm	Perform the test with the vehicle stopped and the engine idling.

   OK

   Tachometer indication is normal.

NG → See step   6 

OK: Go to next step 

1. Connect the Techstream to the DLC3.
2. Start the engine.
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Combination Meter / Data List.
5. According to the display on the Techstream, read the Data List.
   COMBINATION METER
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Engine Rpm	Engine speed/ Min.: 0, Max.: 12750	Approximately same as actual engine speed (when engine is running)	Unit: rpm

   OK

   Engine speed displayed on the Techstream is almost the same as the tachometer indication.

   HINT: 

   Check the engine speed when the engine is fully warmed up, and the air conditioning and all electrical accessories are off.

NG → See step   6 

OK: Go to next step 

1. Check if a engine control DTC is output.Refer to DTC CHECK / CLEAR .
   RESULT
   
   

   Result	Proceed to
   Engine control DTC is not output	A
   Engine control DTC is output	B

B → See step   7 

A → See step   6