Speedometer Malfunction: Procedure

1. Check if a CAN communication DTC is output.Refer to DIAGNOSIS SYSTEM .
   RESULT
   
   

   Result	Proceed to
   CAN communication DTC is not output	A
   CAN communication DTC is output	B

B → See step   5 

A: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Combination Meter / Active Test.
5. According to the display on the Techstream, perform the Active Test.
   COMBINATION METER
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Speed Meter Operation	Speedometer	0/40/80/120/160*1/200*1 km/h (mph)	Perform the test with the vehicle stopped and the engine idling.

   • *1: except U.S.A.

   OK

   Speedometer indication is normal.

NG → See step   6 

OK: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Combination Meter / Data List.
5. According to the display on the Techstream, read the Data List.
   COMBINATION METER
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Vehicle Speed Meter	Vehicle speed/ Min.: 0 (0), Max.: 255 (158)	Approximately same as actual vehicle speed (When vehicle is being driven)	Unit: km/h (mph)

   OK

   Vehicle speed displayed on the Techstream is almost the same as the speedometer indication.

NG → See step   6 

OK: Go to next step 

1. Check if a vehicle stability control DTC is output.Refer to DTC CHECK / CLEAR .
   RESULT
   
   

   Result	Proceed to
   Vehicle stability control DTC is not output	A
   Vehicle stability control DTC is output	B

B → See step   7 

A → See step   6