Entire Combination Meter does not Operate: Procedure

Fig 1: Identifying E13 Combination Meter Assembly Connector Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Disconnect the E13 combination meter assembly connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   E13-21 (ES) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Switch Condition	Specified Condition
   E13-2 (IG+) - Body ground	Ignition switch ON	11 to 14 V
   E13-1 (B) - Body ground	Always	11 to 14 V

   TEXT IN ILLUSTRATION
   
   

   *a	Front view of wire harness connector (to Combination Meter Assembly)

4. Reconnect the combination meter connector.

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → See step   2