Inspection Procedure
WARNING: This page is about a different car, the 2011 Toyota Matrix. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Perform the universal trip to clear permanent DTCs. Refer to DTC CHECK / CLEAR .
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
NOTE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
- READ DATA LIST
- Warm up the engine.
- Turn the ignition switch off.
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn on the Techstream.
- Select the item "Powertrain / Engine and ECT / Data List".
- According to the display on the tester, read the "Data List".
Tester Display Measurement Item/Range Normal Condition Diagnostic Note Neutral Position SW Signal PNP Switch Status/
ON or OFFShift lever position is:
P and N: ON
Except P and N: OFFWhen the shift lever position displayed on the Techstream differs from the actual position, adjustment of the PNP switch or the shift cable may be incorrect. Shift SW Status (R Range) PNP Switch Status/
ON or OFFShift lever position is:
R: ON
Except R: OFF↑ Shift SW Status (P Range) PNP Switch Status/
ON or OFFShift lever position is:
P: ON
Except P: OFF↑ Shift SW Status (N Range) PNP Switch Status/
ON or OFFShift lever position is:
N: ON
Except N: OFF↑ Shift SW Status (D Range) PNP Switch Status/
ON or OFFShift lever position is:
D and S: ON
Except D and S: OFF↑ Sports Mode Selection SW Sport Mode Select Switch Status/
ON or OFFShift lever position is:
S, "+" and "-": ON
Except S, "+" and "-": OFF-