Meter / Gauge System: Initialization: Initialization

HINT: 

The ODO/TRIP change switch knob is located on the light side of the combination meter assembly.

1. Turn the ignition switch to ON.
2. Press the ODO/TRIP change switch knob until the TRIP A meter appears.
3. Turn the ignition switch off.
4. Turn the ignition switch to ON while pressing and holding the ODO/TRIP change switch knob. Hold the ODO/TRIP change switch knob until the following conditions are met and 5 seconds have elapsed.
5. w/o Multi-information Display:
   1. The TRIP A meter shows "000000".
   2. The maintenance required reminder light goes off.
6. w/ Multi-information Display:
   1. The TRIP A meter shows "000000".
   2. The multi-information display shows that the reset is complete.