Child Restraint Seat Tether Anchor: Removal: Removal
- PRECAUTION NOTE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work. Refer to PRECAUTION .
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL WARNING:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTE:When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .
- REMOVE REAR SEAT CUSHION ASSEMBLY . Refer to REMOVAL - Step 3 .
- REMOVE REAR SEAT CUSHION LOCK HOOK . Refer to REMOVAL - Step 4 .
- REMOVE INNER LUGGAGE COMPARTMENT TRIM PAD . Refer to REMOVAL - Step 5 .
- REMOVE REAR SEATBACK ASSEMBLY LH . Refer to REMOVAL - Step 6 .
- REMOVE REAR SIDE SEATBACK ASSEMBLY LH . Refer to REMOVAL - Step 8 .
- REMOVE REAR SIDE SEATBACK ASSEMBLY RH . Refer to REMOVAL - Step 9 .
- DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH . See step 12.
- DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH . See step 13.
- REMOVE ROOF SIDE INNER GARNISH LH . Refer to REMOVAL - Step 24 .
- REMOVE ROOF SIDE INNER GARNISH RH
HINT:
Use the same procedure as for the LH side.
- DISCONNECT REAR SEAT OUTER BELT ASSEMBLY (for LH Side) . See step 13.
- DISCONNECT REAR SEAT OUTER BELT ASSEMBLY (for RH Side) . See step 14.
- REMOVE CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY LH . See step 10.
- DISCONNECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY LH . See step 19.
- REMOVE CENTER STOP LIGHT SET . Refer to REMOVAL - Step 1 .
- REMOVE CHILD RESTRAINT SEAT TETHER ANCHOR COVER . See step 18.
- REMOVE REAR SEAT SHOULDER BELT COVER . See step 19.
- REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY . See step 20.
- REMOVE CHILD RESTRAINT SEAT TETHER ANCHOR BRACKET
- Remove the bolt and child restraint seat tether anchor bracket.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
HINT:
Use the same procedure for the other 2 child restraint seat tether anchor brackets.
- Remove the bolt and child restraint seat tether anchor bracket.