LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2012 >> Camry L >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Safety Connect System (Diagnostic Codes & Symptom Tests) (Except Hybrid) >> Safety Connect System >> Symptom Tests >> Green And Red Indicators Blink Simultaneously >> Procedure

Green And Red Indicators Blink Simultaneously: Procedure

  1. CHANGE SUBSCRIPTION MODE 
    1. Turn the engine switch on (IG).
    2. Push the manual (SOS) switch.
    3. The vehicle will issue a voice prompt: "Safety Connect is not initialized. To activate, please press the button again within 5 seconds."
    4. Push the manual (SOS) switch and a beep will be emitted.
    5. The telematics service provider will send an End Call command and the manual (SOS) switch green indicator will illuminate.
    6. A voice prompt will state: "Activation Complete" (This may take up to 3 minutes)
    7. Turn the engine switch off.

    NEXT: Go to next step 

  2. CHECK SUBSCRIPTION MODE 
    1. Turn the engine switch on (IG).
    2. Confirm that the manual (SOS) switch red indicator illuminates for 2 seconds and turns off and the manual (SOS) switch green indicator illuminates and remains on. Refer to SYSTEM DESCRIPTION .

    NEXT → END 

scientia non olet · About LEMON Manuals