DTC B1583: GPS Signal Unreceived: Procedure
- CHECK TELEPHONE AND GPS ANTENNA ASSEMBLY
- Check that there are no problems with the telephone and GPS antenna assembly.
OK
The antenna is not excessively dirty, and there are no objects blocking signal reception.
NG → REMOVE FOREIGN OBJECT
OK: Go to next step
- Check that there are no problems with the telephone and GPS antenna assembly.
- REPLACE TELEPHONE AND GPS ANTENNA ASSEMBLY
- Replace the telephone and GPS antenna assembly. Refer to REMOVAL .
NEXT: Go to next step
- CLEAR DTC
- Clear the DTCs. Refer to DTC CHECK / CLEAR .
NEXT: Go to next step
- CHECK DTC
- Drive the vehicle for at least 15 miles, manual (SOS) switch red indicator will illuminate at approximately 10 miles if problem still exists.
- Turn the engine switch off.
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG) and wait for 10 seconds.
- Turn the Techstream on.
- Perform "Health Check" and check for current DTCs. Refer to HEALTH CHECK
.
HINT:
Basically, turning the engine switch off will clear the current DTC until vehicle is driven about 10 miles again with the issue.
Result
Result Proceed to DTC B1583 is output A DTC B1583 is not output B
B → END
A: Go to next step
- REPLACE DCM (TELEMATICS TRANSCEIVER)
- Replace the DCM (Telematics Transceiver). Refer to REMOVAL
.NOTE:
- The engine switch must be off.
- Do not swap the DCM (Telematics Transceiver) with one from another vehicle.
NEXT → See step 6
- Replace the DCM (Telematics Transceiver). Refer to REMOVAL
.
- PERFORM DCM ACTIVATION. Refer to DCM ACTIVATION .