Guide Lines are Displayed with Vehicle Center Line: Procedure

CHECK SCREEN MODE

Check the back guide monitor screen.

Fig 1: Checking Screen Mode

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Result

Result	Proceed to
Guide lines are displayed with vehicle center line.	A
Guide lines are displayed without vehicle center line.	B

TEXT IN ILLUSTRATION

*a	Vehicle Center Line

B → See step 4

A: Go to next step

CHECK HARNESS AND CONNECTOR (REAR TELEVISION CAMERA ASSEMBLY - BODY GROUND)

Disconnect the T6 connector from the rear television camera assembly.

Fig 2: Checking T6 Connector Terminal

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Measure the resistance according to the value(s) in the table below.

Standard Resistance

Tester Connection	Condition	Specified Condition
T6-1 (CURT) - Body ground	Always	Below 1 Ω

TEXT IN ILLUSTRATION

*a	Front view of wire harness connector (to Rear Television Camera Assembly)

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR

OK → See step 3

REPLACE REAR TELEVISION CAMERA ASSEMBLY. Refer to REMOVAL .
USE SIMULATION METHOD TO CHECK (A WIRE MAY BE OPEN). Refer to ELECTRONIC CIRCUIT INSPECTION PROCEDURE .