LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2012 >> Camry Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 97 (Hybrid Battery System (Diagnostic Codes (P0A7F-123 - U029A-123)) (Hybrid)) >> Hybrid Battery System >> DTC P0AFC-123: Hybrid Battery Pack Sensor Module >> Confirmation Driving Pattern

Confirmation Driving Pattern

WARNING: This page is about a different variant/trim than selected.
  1. Connect the Techstream to the DLC3.
  2. Turn the power switch on (IG) and turn the Techstream on.
  3. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
  4. Turn the power switch off.
  5. Turn the power switch on (READY) and turn the Techstream on.
  6. Perform the universal trip.
  7. Enter the following menus: Powertrain / HV / Trouble Codes.
  8. Check that permanent DTCs are cleared.

    HINT: 

    • If a permanent DTC is output, the system is malfunctioning.
    • If no permanent DTC is output, the system is normal.
scientia non olet · About LEMON Manuals