DTC P0AC0-123: Hybrid Battery Pack Current Sensor Circuit Range / Performance: Procedure

WARNING: This page is about a different variant/trim than selected.

CHECK DTC OUTPUT (HYBRID CONTROL)

Read output DTCs. Refer to DTC CHECK / CLEAR .

Result

Result	Proceed to
P0AFC-123 or P0A95-123 is not output.	A
P0AFC-123 or P0A95-123 is also output.	B

B → GO TO DTC CHART (HYBRID BATTERY SYSTEM). Refer to DIAGNOSTIC TROUBLE CODE CHART

A: Go to next step

REPLACE HYBRID BATTERY JUNCTION BLOCK ASSEMBLY
Refer to COMPONENTS

NEXT: Go to next step
CLEAR DTC (HYBRID CONTROL)
1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
4. Clear the DTCs and freeze frame data. Refer to DTC CHECK / CLEAR .
5. Perform a road test to charge and discharge the HV battery.
  HINT:
  
  2 trip detection logic is used. After the first road test, turn the power switch off and perform a road test again.
6. Turn the power switch off.
7. Disconnect the Techstream from the DLC3.
NEXT: Go to next step

RECONFIRM DTC OUTPUT (HYBRID CONTROL)

Read output DTCs. Refer to DTC CHECK / CLEAR .

Result

Result	Proceed to
P0AC0-123 is not output.	A
P0AC0-123 is output.	B

B → See step 5

A → RECOVERY TO NORMAL