Front Door Belt Moulding: Removal: Removal

PRECAUTION
NOTE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work. Refer to PRECAUTION .
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
WARNING:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .
REMOVE OUTER REAR VIEW MIRROR ASSEMBLY
Refer to REMOVAL .
REMOVE DOOR SIDE AIRBAG SENSOR . Refer to REMOVAL - Step 10 .
REMOVE FRONT DOOR SERVICE HOLE COVER . Refer to DISASSEMBLY - Step 15 .
REMOVE FRONT DOOR GLASS SUB-ASSEMBLY . Refer to DISASSEMBLY - Step 16 .
REMOVE FRONT DOOR BELT MOULDING ASSEMBLY
1. Put protective tape around the front door belt moulding assembly.
  
  Fig 1: Identifying Protective Tape On Front Door Belt Moulding Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  TEXT IN ILLUSTRATION
  
  *1 Protective Tape
2. Using a screwdriver with the tip wrapped with protective tape, disengage the 6 claws and remove the front door belt moulding assembly.
  
  Fig 2: Identifying Front Door Belt Moulding Assembly Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  TEXT IN ILLUSTRATION
  
  *1 Protective Tape
  
  HINT:
  
  Tape the screwdriver tip before use.