On-Vehicle Inspection
WARNING: This page is about a different variant/trim than selected.
- INSPECT NO. 2 IGNITION RELAY
- Measure the resistance according to the value(s) in the table below.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Standard Resistance
| Tester Connection |
Condition |
Specified Condition |
| 3 - 5 |
No battery voltage applied |
10 kΩ or higher |
| Battery voltage applied between terminals 1 and 2 |
Below 1 Ω |
If the result is not as specified, replace the relay.