Display Signal Circuit between Video Terminal and Television Display: Procedure

CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY ASSEMBLY - VIDEO TERMINAL)

Disconnect the television display assembly and video terminal connectors.

Measure the resistance according to the value(s) in the table below.

Standard resistance

Tester Connection	Condition	Specified Condition
Q13-6 (NTS4) - O25-5 (VV+)	Always	Below 1 Ω
Q13-22 (SGN5) - O25-6 (VV-)	Always	Below 1 Ω
Q13-25 (SGN2) - O25-7 (SG)	Always	Below 1 Ω
Q13-24 (OPEN) - O25-8 (ADPG)	Always	Below 1 Ω
Q13-6 (NTS4) - Body ground	Always	10 kΩ or higher
Q13-22 (SGN5) Body ground	Always	10 kΩ or higher
Q13-25 (SGN2) - Body ground	Always	10 kΩ or higher
Q13-24 (OPEN) - Body ground	Always	10 kΩ or higher

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR

OK → See step 2

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE