Rear Strut Rod: Removal: Removal

HINT: 

• Use the same procedure for the RH side and LH side.
• The procedure listed below is for the LH side.

1. REMOVE REAR WHEEL 
2. SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY 
   1. Remove the nut and separate the No. 3 parking brake cable assembly.
      Fig 1: Locating Parking Brake Cable Assembly No. 3 With Nut

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. REMOVE REAR STRUT ROD ASSEMBLY 
   1. Remove the 2 bolts, the 2 nuts, and the rear strut rod assembly.
      Fig 2: Locating Rear Strut Rod Assembly Bolts And Nuts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      Since stopper nuts are used, loosen the bolts.