LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2011 >> Highlander Hybrid >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Air Conditioning (Manual) (Diagnostic Codes & Circuit Tests) (Hybrid) >> Solar Sensor >> Installation >> Installation

Solar Sensor: Installation: Installation

  1. INSTALL SOLAR SENSOR 
    1. Engage the 2 claws and install the solar sensor.
      Fig 1: Identifying Solar Sensor Claws
      GTY179104Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Connect the connector.
  2. INSTALL DEFROSTER NOZZLE ASSEMBLY  . Refer to REASSEMBLY - Step 10
  3. INSTALL SIDE NO. 2 DEFROSTER NOZZLE DUCT  . Refer to REASSEMBLY - Step 11
  4. INSTALL SIDE NO. 1 DEFROSTER NOZZLE DUCT  . Refer to REASSEMBLY - Step 12
  5. INSTALL NO. 4 HEATER TO REGISTER DUCT  . Refer to REASSEMBLY - Step 13
  6. INSTALL NO. 1 HEATER TO REGISTER DUCT  . Refer to REASSEMBLY - Step 14
  7. INSTALL INSTRUMENT PANEL SAFETY PAD ASSEMBLY  . Refer to INSTALLATION - Step 4
  8. CONNECT INSTRUMENT PANEL WIRE ASSEMBLY  . Refer to INSTALLATION - Step 1
  9. INSTALL FRONT NO. 2 SPEAKER ASSEMBLY (for LH Side)  . Refer to INSTALLATION - Step 1
  10. INSTALL NO. 1 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY  . Refer to INSTALLATION - Step 7
  11. INSTALL FRONT NO. 2 SPEAKER ASSEMBLY (for RH Side)  . Refer to INSTALLATION - Step 1
  12. INSTALL NO. 2 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY  . Refer to INSTALLATION - Step 9
  13. INSTALL FRONT PILLAR GARNISH RH  . Refer to INSTALLATION - Step 96
  14. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH  . Refer to INSTALLATION - Step 97
  15. INSTALL FRONT PILLAR GARNISH LH  . Refer to INSTALLATION - Step 87
  16. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH  . Refer to INSTALLATION - Step 88
  17. INSTALL POWER SWITCH  . Refer to INSTALLATION - Step 1
  18. INSTALL FRONT NO. 2 CONSOLE BOX INSERT  . Refer to INSTALLATION - Step 15
  19. INSTALL FRONT NO. 1 CONSOLE BOX INSERT  . Refer to INSTALLATION - Step 16
  20. INSTALL CONSOLE BOX ASSEMBLY  . Refer to REMOVAL - Step 5
  21. INSTALL LOWER REAR CONSOLE BOX  . Refer to INSTALLATION - Step 2
  22. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY  . Refer to INSTALLATION - Step 19
  23. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY  . Refer to INSTALLATION - Step 24
  24. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH  . Refer to INSTALLATION - Step 89
  25. INSTALL FRONT DOOR SCUFF PLATE LH  . Refer to INSTALLATION - Step 90
  26. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY  . Refer to INSTALLATION - Step 24
  27. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY  . Refer to INSTALLATION - Step 21
  28. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH  . Refer to INSTALLATION - Step 98
  29. INSTALL FRONT DOOR SCUFF PLATE RH  . Refer to INSTALLATION - Step 99
  30. INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET (w/o Navigation System)  . Refer to INSTALLATION - Step 7
  31. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKET (w/ Navigation System)  . Refer to INSTALLATION - Step 4
  32. INSTALL AIR CONDITIONING CONTROL ASSEMBLY  . Refer to INSTALLATION - Step 1
  33. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (w/o Smart Key System)  . Refer to INSTALLATION - Step 31
  34. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (w/ Smart Key System)  . Refer to INSTALLATION - Step 32
  35. INSTALL CENTER INSTRUMENT PANEL REGISTER ASSEMBLY  . Refer to INSTALLATION - Step 33
  36. INSTALL COMBINATION METER ASSEMBLY  . Refer to INSTALLATION - Step 1
  37. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY  . Refer to INSTALLATION - Step 35
  38. POSITION FRONT WHEELS STRAIGHT AHEAD 
  39. INSTALL TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY  . Refer to INSTALLATION - Step 6
  40. INSTALL STEERING COLUMN COVER  . Refer to INSTALLATION - Step 7
  41. ADJUST SPIRAL CABLE SUB-ASSEMBLY  . Refer to INSTALLATION - Step 4
  42. INSTALL STEERING WHEEL ASSEMBLY  . Refer to INSTALLATION - Step 3
  43. INSPECT STEERING WHEEL CENTER POINT 
  44. INSTALL STEERING PAD  . Refer to INSTALLATION - Step 1
  45. INSTALL LOWER NO. 2 STEERING WHEEL COVER  . Refer to INSTALLATION - Step 3
  46. INSTALL LOWER NO. 3 STEERING WHEEL COVER  . Refer to INSTALLATION - Step 2
  47. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected, refer to INITIALIZATION .

  48. INSPECT STEERING PAD  . Refer to INSTALLATION - Step 7
  49. INSPECT SRS WARNING LIGHT 
    1. Inspect the SRS warning light, refer to CHECK MODE PROCEDURE .
scientia non olet · About LEMON Manuals