DTC B1443/43: Air Outlet Damper Control Servo Motor Circuit: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON and turn the Techstream main switch on.
3. Select the items below in the Data List, and read the value displayed on the Techstream.
   DATA LIST / AIR CONDITIONER
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Air Outlet Servo Pulse(D)	Mode damper servo sub-assembly target pulse / Min.: 0, Max.: 255	FACE: 8 (pulse) B/L: 30 (pulse) FOOT: 67 (pulse) FOOT/DEF: 80 (pulse) DEF: 97 (pulse)	-

   OK

   The display is as specified in the normal condition column.

   Result

   Result	Proceed to
   NG	A
   OK (When troubleshooting according to PROBLEM SYMPTOMS TABLE)	B
   OK (When troubleshooting according to DTC)	C

B → See step   4 

C → See step   5 

A: Go to next step 

1. Replace the mode damper servo sub-assembly, refer to REMOVAL .

NEXT: Go to next step 

1. Check for DTCs.

   OK

   DTC B1443/43 is not output.

NG → REPAIR AIR CONDITIONING HARNESS 

OK → END (MODE DAMPER SERVO SUB-ASSEMBLY IS DEFECTIVE)