LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2011 >> Highlander Hybrid >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 65 (Fuel System (2GR-FE) (Service Information)) >> Fuel Pump Resistor >> Installation >> Installation

Fuel Pump Resistor: Installation: Installation

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL FUEL PUMP RESISTOR 
    1. Install the fuel pump resistor cover.
      Fig 1: Identifying Fuel Pump Resistor Cover
      GTY178642Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the fuel pump resistor with the nut.
      Fig 2: Identifying Fuel Pump Resistor & Nut
      GTY178794Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 19 N*m (194 kgf*cm, 14 ft.*lbf) 

    3. Connect the connector.
  2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL  . Refer to INSTALLATION - Step 4
  3. INSPECT SRS WARNING LIGHT  . Refer to INSTALLATION - Step 6
scientia non olet · About LEMON Manuals