Oil Pump: Reassembly: Reassembly

WARNING: This page is about a different variant/trim than selected.

INSTALL FRONT OIL PUMP OIL SEAL
1. Using SST and a hammer, install a new oil seal to the oil pump body.
  
  Fig 1: Installing Oil Seal To Oil Pump Body
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  - SST: 09350-32014
    - 09351-32140
  NOTE:
  The seal end should be level with the outer edge of the oil pump.
2. Coat the lip of the oil seal with MP grease.
INSTALL FRONT OIL PUMP BODY O-RING
1. Coat a new O-ring with ATF and install it to the oil pump body.
  
  Fig 2: Identifying O-Ring And Oil Pump Body
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  NOTE:
  Ensure that the O-ring is not twisted.
INSTALL FRONT OIL PUMP DRIVEN GEAR
1. Coat the front oil pump driven gear with ATF and install it to the oil pump body with the marked side up.
  
  Fig 3: Identifying Front Oil Pump Driven Gear
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT OIL PUMP DRIVE GEAR
1. Coat the front oil pump drive gear with ATF, and install it to the oil pump body with the marked side up.
  
  Fig 4: Identifying Front Oil Pump Drive Gear
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

INSTALL STATOR SHAFT ASSEMBLY

Align each knock pin of the stator shaft with the holes in the oil pump body and install the stator shaft to the oil pump body with the 16 bolts.

Fig 5: Locating Stator Shaft Assembly Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Using a "TORX" socket (T30), install the 16 bolts.

Torque: 9.3 N*m (95 kgf*cm, 82 in.*lbf)

-	Bolt length
Bolt A	14 mm (0.551 in)
Bolt B	26 mm (1.02 in)