LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2011 >> Highlander Hybrid >> Repair and Diagnosis >> Electrical >> Horns >> Horn (Service Information) (Hybrid) >> Spiral Cable >> Removal >> Removal

Spiral Cable: Removal: Removal

  1. PRECAUTION 
    WARNING:

    Be sure to read "PRECAUTION" thoroughly before servicing, refer to PRECAUTION .

  2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD 
  3. REMOVE DECK BOARD ASSEMBLY  . Refer to REMOVAL - Step 1
  4. REMOVE BATTERY SERVICE HOLE COVER ASSEMBLY  . Refer to REMOVAL - Step 2
  5. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    WARNING:

    Wait for 90 seconds after disconnecting the cable to prevent airbag deployment, refer to DIAGNOSIS SYSTEM .

    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected, refer to INITIALIZATION .

  6. REMOVE LOWER NO. 3 STEERING WHEEL COVER  . Refer to REMOVAL - Step 5
  7. REMOVE LOWER NO. 2 STEERING WHEEL COVER  . Refer to REMOVAL - Step 6
  8. REMOVE STEERING PAD  . Refer to REMOVAL - Step 7
  9. REMOVE STEERING WHEEL ASSEMBLY  . Refer to REMOVAL - Step 8
  10. REMOVE STEERING COLUMN COVER  . Refer to REMOVAL - Step 10
  11. REMOVE SPIRAL CABLE WITH STEERING ANGLE SENSOR  . Refer to REMOVAL - Step 11
  12. REMOVE SPIRAL CABLE 
    1. Disengage the 6 claws and 2 pins, and remove the spiral cable from the steering angle sensor.
      Fig 1: Identifying Spiral Cable Claws And Pins
      GTY139962Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals