Power Meter Gauge Malfunction: Procedure

1. Check for the DTC.
   • w/ Smart Key System:, refer to DIAGNOSIS SYSTEM
   • w/o Smart Key System:, refer to DIAGNOSIS SYSTEM
   RESULT
   
   

   Result	Proceed to
   DTC is not output	A
   CAN communication system DTC is output (w/ Smart Key System)	B
   CAN communication system DTC is output (w/o Smart Key System)	C
   Hybrid control system DTC is output	D

B → See step   4 

C → See step   7 

D → See step   5 

A: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter following menus: Body Electrical / Combination Meter / Active Test.
5. Check the operation by referring to the table below.
   COMBINATION METER:
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Power Meter Operation	Power meter	0, 50, 100, 150, 200, MAX (kW)	Confirm that the vehicle is stopped, engine idling

   OK

   Needle indication is normal.

NG → See step   6 

OK → See step   3