Meter Illumination is Always Dark: Procedure

1. Check if CAN communication DTC is output.
   • w/ Smart Key System:, refer to DIAGNOSIS SYSTEM
   • w/ Smart Key System:, refer to DIAGNOSIS SYSTEM
   RESULT
   
   

   Result	Proceed to
   CAN communication system DTC is not output.	A
   CAN communication system DTC is output. (w/ Smart Key System)	B
   CAN communication system DTC is output. (w/o Smart Key System)	C

B → See step   5 

C → See step   8 

A: Go to next step 

1. Check if DTC B1244 is output, refer to DTC CHECK / CLEAR .
   RESULT
   
   

   Result	Proceed to
   B1244 is not output.	A
   B1244 is output.	B

B → See step   6 

A: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Turn the light control switch to the TAIL or HEAD position.
5. Enter the following menus: Body Electrical / Main Body / Active Test.
6. Check the meter illumination.
   MAIN BODY:
   
   

   Tester Display	Test Part	Normal Condition	Diagnostic Note
   Dimmer signal	Dimmer signal	Dimmer signal is OFF/ON	-

   OK

   Meter illumination does not dim when turn the light control switch to the TAIL or HEAD position and dimmer signal is ON in daytime.

   HINT: 

   Meter illumination is adjusted by automatic light control system and controlled according to the outside light. The automatic light control sensor sensitiveness can be customized. Therefore, when the Data List value is normal, confirm the sensitivity setting in the customization table of the automatic light control system.

NG → See step   4 

OK → See step   7 

1. Replace the combination meter assembly with a new or normally functioning one, refer to REMOVAL .

   OK

   The operation of the combination meter assembly returns to normal.

NG → REPLACE MAIN BODY ECU 

OK → END (COMBINATION METER ASSEMBLY IS DEFECTIVE)