Entire Combination Meter does not Operate: Procedure

1. Disconnect the E1 meter connector.
   Fig 1: Identifying E1 Combination Meter Assembly Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Measure the resistance according to the value(s) in the table below.

   Standard resistance

   Tester Connection	Condition	Specified Condition
   E1-20 (ES) - Body ground	Always	Below 1 Ω
   E1-40 (E2) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard voltage

   Tester Connection	Condition	Specified Condition
   E1-1 (IG+) - Body ground	Ignition switch ON	11 to 14 V
   E1-21 (B) - Body ground	Always	11 to 14 V
   E1-22 (B2) - Body ground	Always	11 to 14 V

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → See step   2