Brake Master Cylinder: Disassembly: Disassembly

REMOVE BRAKE STROKE SIMULATOR BRACKET
1. Disconnect the connector.
  
  Fig 1: Identifying Brake Stroke Simulator Bracket Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the 2 bolts and brake stroke simulator bracket from the brake stroke simulator cylinder sub-assembly.
REMOVE MASTER CYLINDER PUSH ROD CLEVIS
1. Loosen the lock nut, and remove the master cylinder push rod clevis and lock nut.
  HINT:
  
  If the protrusion of the push rod in relation to the push rod clevis is measured beforehand, it is easier to perform the brake pedal height adjustment after the brake master cylinder sub-assembly is installed.
  
  Fig 2: Identifying Master Cylinder Push Rod Clevis And Lock Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE MASTER CYLINDER RESERVOIR GROMMET
1. Remove the screw and brake master cylinder union.
  
  Fig 3: Identifying Master Cylinder Reservoir Grommet
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the 2 master cylinder reservoir grommets from the brake master cylinder union.