Slip Indicator Light does not Come ON: Procedure

B → See step   4 

C → See step   7 

A: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Select the Active Test on the Techstream, refer to DATA LIST / ACTIVE TEST .
   ABS/VSC/TRAC
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Slip Indicator Light	Slip indicator light	Indicator light ON/OFF	Observe combination meter

4. Check that the slip indicator light in the combination meter turns on and off in accordance with the Techstream operation.

   OK

   The slip indicator light turns on and off in accordance with the Techstream operation.

   HINT: 

   If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next suspected area before replacing the part, refer to PROBLEM SYMPTOMS TABLE .

NG → See step   3 

OK → See step   5 

1. Turn the ignition switch off.
2. Perform the Active Test of the combination meter (meter CPU) using the Techstream, refer to DATA LIST / ACTIVE TEST .
3. Check the combination meter.

   OK

   The slip indicator light turns on and off in accordance with the Techstream operation.

   HINT: 

   If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next suspected area, refer to PROBLEM SYMPTOMS TABLE .

NG → See step   6 

OK → See step   5