Slip Indicator Light Remains ON: Procedure

B → See step   6 

C → See step   8 

A: Go to next step 

1. Check if the skid control ECU connector is securely connected.

   OK

   The connector is securely connected.

NG → CONNECT CONNECTOR TO ECU CORRECTLY 

OK: Go to next step 

1. Check the auxiliary battery voltage.

   Standard Voltage

   11 to 14 V

NG → CHARGE OR REPLACE AUXILIARY BATTERY 

OK: Go to next step 

1. Perform the Active Test of the combination meter (meter CPU) using the Techstream, refer to DATA LIST / ACTIVE TEST .
2. Check the combination meter.

   OK

   The slip indicator light turns on and off in accordance with the Techstream operation.

   HINT: 

   If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next suspected area before replacing the part, refer to PROBLEM SYMPTOMS TABLE .

NG → See step   7 

OK → See step   5