LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2011 >> Highlander Hybrid >> Repair and Diagnosis >> Brakes >> Anti-Lock Brakes >> Electronically Controlled Brake System (Diagnostic Codes & Symptom Tests) (Hybrid) >> Electronically Controlled Brake System >> DTC C1464/31: Front Speed Sensor RH Circuit; DTC C1271/71: Low Output Signal of Front Speed Sensor RH (Test Mode DTC); DTC C1272/72: Low Output Signal of Front Speed Sensor LH (Test Mode DTC); DTC C1465/32: Front Speed Sensor LH Circuit >> Description

DTC C1464/31: Front Speed Sensor RH Circuit; DTC C1271/71: Low Output Signal of Front Speed Sensor RH (Test Mode DTC); DTC C1272/72: Low Output Signal of Front Speed Sensor LH (Test Mode DTC); DTC C1465/32: Front Speed Sensor LH Circuit: Description

The speed sensor detects the wheel speed and sends the appropriate signals to the skid control ECU. These signals are used for ABS control.

DTCs C1271/71 and C1272/72 can be cleared when the speed sensor sends a wheel speed signal or when Test Mode ends. DTCs C1271/71 and C1272/72 are output only in Test Mode.

HINT: 

When the connectors between the speed sensor and skid control ECU are connected, the following waveform is output.

Fig 1: Identifying Speed Sensor Rotor Waveform Graph
GTY298333Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
DTC Code INF Code DTC Detection Condition Trouble Area
C1464/31 251 At a vehicle speed of 10 km/h (6 mph) or more, an open or short signal occurs in the speed sensor circuit.
  • Front speed sensor RH
  • Speed sensor circuit
  • Sensor installation
  • Speed sensor rotor
  • Skid control ECU
252 More than one speed sensor circuit signal is abnormal.
253 Speed sensor circuit signal is open for 0.5 seconds or more.
254 A momentary interruption of the sensor signal from the speed sensor occurs 255 times or more.
255 Frequency of 2.4 kHz or more is input.
  • Front speed sensor RH
  • Speed sensor circuit
  • Speed sensor rotor
  • Skid control ECU
262 Either of the following is detected:
  1. With the voltage of the IG1 terminal at 9.5 V or more, the sensor power supply voltage decreases for 0.5 seconds or more.
  2. With the voltage of the IG1 terminal at 9.5 V or more, the sensor power supply voltage fluctuates for 60 seconds or more.
  • Speed sensor circuit
  • Skid control ECU
C1465/32 264 At a vehicle speed of 10 km/h (6 mph) or more, an open or short signal occurs in the speed sensor circuit.
  • Front speed sensor LH
  • Speed sensor circuit
  • Sensor installation
  • Speed sensor rotor
  • Skid control ECU
265 More than one speed sensor circuit signal is abnormal.
266 Speed sensor circuit signal is open for 0.5 seconds or more.
267 A momentary interruption of the sensor signal from the speed sensor occurs 255 times or more.
268 Frequency of 2.4 kHz or more is input.
  • Front speed sensor LH
  • Speed sensor circuit
  • Speed sensor rotor
  • Skid control ECU
275 Either of the following is detected:
  1. With the voltage of the IG1 terminal at 9.5 V or more, the sensor power supply voltage decreases for 0.5 seconds or more.
  2. With the voltage of the IG1 terminal at 9.5 V or more, the sensor power supply voltage fluctuates for 60 seconds or more.
  • Speed sensor circuit
  • Skid control ECU
C1271/71
C1272/72
- Detected only during Test Mode.
  • Front speed sensor RH/LH
  • Sensor installation
  • Speed sensor rotor

HINT: