DTC C1442/44: Invalid Data Received from Acceleration Sensor; DTC C1443/34: Invalid Data Received from Yaw Rate Sensor: Procedure

1. Clear the DTCs, refer to DTC CHECK / CLEAR .
2. Turn the ignition switch to ON (READY).
3. Run the engine for 60 seconds, and then turn the ignition switch off.
4. Check if the same DTC is recorded, refer to DTC CHECK / CLEAR .

   Result

   Result	Proceed to
   DTCs (C1442/44 and/or C1443/34) are output	A
   DTCs (C1442/44 and C1443/34) are not output	B

B → See step   3 

A → See step   2