DTC C1440/98: Unusual Bank Angle Detected: Procedure

1. Clear the DTCs, refer to DTC CHECK / CLEAR .
2. Perform a road test.
3. Check if the same DTC is recorded, refer to DTC CHECK / CLEAR .

   Result

   Result	Proceed to
   DTC (C1440/98) is output	A
   DTC (C1440/98) is not output	B
   Yaw rate and acceleration sensor DTC is output	C

B → END 

C → See step   3 

A: Go to next step 

1. Clear the DTCs, refer to DTC CHECK / CLEAR .

   HINT: 

   • If the skid control ECU determines that the vehicle is being driven at a steep bank angle, the skid control ECU stores DTC C1440/98 while VSC operation is temporarily disabled.
   • It is not a malfunction if the system and sensor circuits are normal and if normal VSC operation resumes.

NEXT → END