DTC C1345/66: Linear Solenoid Valve Offset Learning Undone; DTC C1368/67: Linear Solenoid Valve Offset Malfunction: Procedure

1. Clear the DTCs, refer to DTC CHECK / CLEAR .
2. Turn the ignition switch off.
3. Turn the ignition switch to ON.
4. Check that the DTCs (electronically controlled brake system and hybrid control system) are recorded, refer to DTC CHECK / CLEAR for electronically controlled brake system, or, refer to DTC CHECK / CLEAR for hybrid control system).

   Result

   Result	Proceed to
   DTCs (except C1345/66, C1368/67 and hybrid control system DTC) are not output	A
   Hybrid control system DTC is output	B
   DTCs (except C1345/66 and/or C1368/67) are output	C

   HINT: 

   Before carrying out Perform Initialization and Calibration of the Linear Solenoid Valve, C1203/95 will be output.

B → See step   4 

C → See step   5 

A: Go to next step 

1. Turn the ignition switch off.
2. Perform initialization and calibration of the linear solenoid valve, refer to INITIALIZATION .

NEXT: Go to next step 

1. Turn the ignition switch off.
2. Clear the DTCs, refer to DTC CHECK / CLEAR .
3. Turn the ignition switch to ON.
4. Check if the same DTC is recorded, refer to DTC CHECK / CLEAR .

   Result

   Result	Proceed to
   DTCs (C1345/66 and C1368/67) are not output	A
   DTCs (C1345/66 and/or C1368/67) are output	B

B → See step   6 

A → END