DTC C1240/95: Yaw Rate Sensor Discrimination: Procedure

1. Check that the proper yaw rate and acceleration sensor is installed.

   OK

   Proper sensor is installed.

NG → See step   4 

OK: Go to next step 

1. Clear the DTCs, refer to DTC CHECK / CLEAR .
2. Check if the same DTC is recorded, refer to DTC CHECK / CLEAR .

   Result

   Result	Proceed to
   DTC (C1240/95) is not output	A
   DTC (C1240/95) is output	B

B → See step   5 

A → See step   3