Jam Protection Function Activates During Power Back Door Operation: Procedure

1. Check if there are any foreign objects interfering with the back door operation.

   OK

   There are no foreign objects.

NG → REMOVE FOREIGN OBJECT 

OK: Go to next step 

1. Check the back door operation.
   1. Turn the door control main switch off.
   2. Open / close the back door by hand.

      OK

      The back door fully opens and closes smoothly.

NG → ADJUST BACK DOOR 

OK: Go to next step 

1. Check the Data List to determine if the power back door touch sensor functions properly.
   BACK DOOR (POWER BACK DOOR ECU)
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   PBD Touch Sen L	Power back door touch sensor LH signal / ON or OFF	ON: Power back door touch sensor LH pressed OFF: Power back door touch sensor LH not pressed	-
   PBD Touch Sen R	Power back door touch sensor RH signal / ON or OFF	ON: Power back door touch sensor RH pressed OFF: Power back door touch sensor RH not pressed	-

   OK

   The power back door sensors function as specified in the normal condition.

NG → See step   5 

OK → See step   4