Data List / Active Test

Performing the ACTIVE TEST using Techstream allows the meters, indicators and so on to operate without removing any parts. Performing the ACTIVE TEST as the first step in troubleshooting is one way to shorten labor time.

1. Connect Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. From the display on the tester, select the "ACTIVE TEST".
   METER:
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Front Passenger Side Seat Belt	Front passenger side seat belt warning light	Front passenger side seat belt warning light is OFF / ON	Confirm that the vehicle is stopped with the engine idling
   Driver Side Seat Belt	Driver side seat belt warning light	Driver side seat belt warning light is OFF / ON	Confirm that the vehicle is stopped with the engine idling