Rear Shock Absorber: Disposal: Disposal

DISPOSE OF REAR SHOCK ABSORBER
1. Fully extend the shock absorber piston rod.
  
  Fig 1: Identifying Drilling Area
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using a drill, make a hole in area B shown in the illustration to discharge the gas inside.
  Length (A)
  
  25 mm (0.98 in.)
  
  Length (B)
  
  25 mm (0.98 in.)
  WARNING:
  - Be careful when drilling because shards of metal may fly about. Always use proper safety equipment.
  - The gas is colorless, odorless and non-poisonous.