LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2011 >> Highlander Hybrid Limited >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Suspension System (Service Information) (Hybrid) >> Front Shock Absorber >> Disposal >> Disposal

Front Shock Absorber: Disposal: Disposal

  1. DISPOSE OF FRONT SHOCK ABSORBER 
    1. Position the front shock absorber assembly level with the piston rod fully extended. Using a drill, make a hole in the cylinder between A and B as shown in the illustration to discharge the gas inside.
      Fig 1: Drilling Hole In Cylinder Between A And B
      GTY162254Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:
      • The gas is colorless, odorless, and nonpoisonous.
      • Be careful when drilling because shards of metal may fly about, so always use proper safety equipment.
scientia non olet · About LEMON Manuals