Inspection Procedure
WARNING: This page is about a different variant/trim than selected.
NOTE:
Inspect the fuse for circuits related to this system before performing the following inspection procedure.
- EMERGENCY ENGINE START CONTROL
- If there is a malfunction in the stop light switch or STOP fuse, their signals may not be correctly transmitted to the main body ECU (instrument panel junction block). This may result in the engine not starting even if the engine switch is pressed while the brake pedal is depressed and the shift lever is in the P position.
To activate the starter:
- Turn the engine switch from off to on (ACC).
- Press and hold the engine switch for 15 seconds.
- If there is a malfunction in the stop light switch or STOP fuse, their signals may not be correctly transmitted to the main body ECU (instrument panel junction block). This may result in the engine not starting even if the engine switch is pressed while the brake pedal is depressed and the shift lever is in the P position.