DTC B2284: Brake Signal Malfunction: Description
WARNING: This page is about a different variant/trim than selected.
HINT:
When the main body ECU (instrument panel junction block) is replaced with a new one and the negative (-) battery terminal is connected, the power source mode becomes the IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.
After the main body ECU (instrument panel junction block) is replaced, perform the registration procedures for the engine immobiliser system, refer to REGISTRATION .
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2284 | The brake signal circuit between the main body ECU (instrument panel junction block) and the stop light switch is malfunctioning and the CAN information is inconsistent |
|