DTC B2281: "P" Signal Malfunction: Description
WARNING: This page is about a different variant/trim than selected.
The ECM and the shift lock control ECU are connected by a cable and the CAN. If the cable information and CAN information are inconsistent, this DTC will be output.
HINT:
If the main body ECU (instrument panel junction block) is replaced with a new one while the negative (-) battery terminal is connected, the power source mode will be in IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored. After the main body ECU (instrument panel junction block) is replaced, perform the registration procedure for the engine immobiliser system, refer to REGISTRATION .
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2281 | Cable information and CAN information between main body ECU (instrument panel junction block) and shift lock control ECU are inconsistent |
|