DTC B2275: STSW Monitor Malfunction: Description
WARNING: This page is about a different variant/trim than selected.
This DTC is output when there is an open, short, or any other problem in the engine start request output circuit inside the main body ECU (instrument panel junction block) or in the external circuit.
HINT:
When the main body ECU is replaced with a new one and the negative (-) battery terminal is connected, the power source mode becomes the IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.
After the main body ECU (instrument panel junction block) is replaced, perform the registration procedures for the engine immobiliser system.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2275 | STSW output circuit (engine starting request signal circuit) inside main body ECU (instrument panel junction block) or other related circuit is malfunctioning |
|