DTC P060B: Internal Control Module A/D Processing Performance: Procedure

WARNING: This page is about a different variant/trim than selected.

CHECK FOR DTC

Connect the Techstream to the DLC3.
Turn the ignition switch on (IG).
Turn the Techstream on.
Clear DTCs. Refer to DTC CHECK / CLEAR .
Turn the Techstream off.
Turn the ignition switch off.
Disconnect the Techstream.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Connect the Techstream to the DLC3.
Turn the ignition switch on (IG) and turn the Techstream on.
Wait 16 seconds or more.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

Check for DTCs.

RESULT

Result	Proceed to
DTC is not output	A
DTC P060B is output	B
DTC P060B and P0327, P0328, P032C, P032D, P0332, P0333, P033C or P033D are output	C

B → See step 3

C → See step 4

A → See step 2

CHECK FOR INTERMITTENT PROBLEMS. Refer to CHECK FOR INTERMITTENT PROBLEMS
REPLACE ECM. Refer to REMOVAL
GO TO DTC P0327, P0328, P032C, P032D, P0332, P0333, P033C OR P033D. Refer to DIAGNOSTIC TROUBLE CODE CHART