Typical Malfunction Thresholds
WARNING: This page is about a different variant/trim than selected.
| Either condition is met | 1 or 2 |
| 1. Both of following conditions A and B met | - |
| A. Engine speed - Target engine speed | Less than -100 RPM, or more than 150 RPM (A/C off and NSW off) Less than -100 RPM, or more than 200 RPM (A/C on or NSW on) |
| B. IAC flow rate learned value | 2.48 L/sec. or less, or 11.0 L/sec. or more for 5 seconds or more |
| 2. Both of following conditions C and D met | - |
| C. Frequency that both of following conditions (a) and (b) met | 5 times or more |
| (a) Engine speed - Target engine speed | Less than -100 RPM, or more than 150 RPM (A/C off and NSW off) Less than -100 RPM, or more than 200 RPM (A/C on or NSW on) |
| (b) Vehicle condition | Stopped after being driven at 10 km/h (6.25 mph) or more |
| D. Either condition is met | (c) or (d) |
| (c) IAC flow rate learned value | 0.88 L/sec. or less, or 8.5 L/sec. or more |
| (d) Amount of change of IAC flow rate learned value | +2.3 L/sec. or more, or -4.2 L/sec. or less |