Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
| The monitor will run whenever these DTCs are not present | None |
| Time after ignition switch off to on (IG) | 3 seconds or more |
| Engine | Running |
| Transmission counter gear speed | 300 RPM or more |
| Battery voltage | 8 V or more |
| Ignition switch | on (IG) |
| Starter | OFF |
| Either of the following conditions is met | Condition 1 or 2 |
| 1. Both of the following conditions are met | Condition (a) or (b) |
| (a) Engine coolant temperature (P0115, P0117, P0118, P0125) | 20°C (68°F) or more |
| (b) Engine coolant temperature sensor fail | Not detected |
| (c) Time after park/neutral position switch ON to OFF | 2 seconds or more |
| 2. Both of the following conditions are met | Conditions (a) and (b) |
| (a) Engine coolant temperature | Less than 20°C (68°F) |
| (b) Engine coolant temperature sensor fail (P0115, P0117, P0118, P0125) | Detected |
| (c) Time after park/neutral position switch ON to OFF | 30 seconds or more |