Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
ALL:
| The monitor will run whenever these DTCs are not present | None |
P0335: CRANKSHAFT POSITION SENSOR RANGE CHECK/RATIONALITY
| Time after starter OFF to ON | 3 seconds or more |
| Battery voltage | 7 V or more |
| Number of VVT sensor signal pulse | 6 times |
| Camshaft position sensor circuit fail (P0340, P0342, P0343) | Not detected |
| Minimum battery voltage while starter ON | Less than 11 V |
P0335: CRANKSHAFT POSITION SENSOR VERIFY PULSE INPUT (CASE 1)
| Engine speed | Less than 600 RPM |
| Starter | OFF |
| Time after starter from ON to OFF | 3 seconds or more |
P0335: CRANKSHAFT POSITION SENSOR VERIFY PULSE INPUT (CASE 2)
| Starter | ON |
| Minimum battery voltage while starter ON | Less than 11 V |