DTC P2610: ECM / PCM Internal Engine Off Timer Performance: Procedure

WARNING: This page is about a different variant/trim than selected.

REPLACE ECM
1. Replace the ECM, refer to COMPONENTS .
NEXT: Go to next step
CHECK WHETHER DTC OUTPUT RECURS
1. Connect the Techstream to the DLC3.
2. Turn the ignition switch on (IG).
3. Clear the DTCs, refer to DTC CHECK / CLEAR .
4. Start the engine and wait for 10 minutes or more.
5. Select the following menu items: Powertrain / Engine and ECT / Trouble Codes / Pending.
6. If no pending DTC is displayed, the repair has been successfully completed.
  OK
  
  No DTC output.
NG → See step 3

OK → END
CHECK FOR INTERMITTENT PROBLEMS. Refer to CHECK FOR INTERMITTENT PROBLEMS