LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2011 >> Highlander Hybrid Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 59 (Wiper System & Washer System (Service Information)) >> Wiper Switch >> Removal >> Removal

Wiper Switch: Removal: Removal

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE STEERING COLUMN COVER 
    1. Turn the steering wheel assembly to the right and remove the screw as shown in the illustration.
      Fig 1: Locating Steering Wheel Assembly Screw (Right)
      GTY188061Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Turn the steering wheel assembly to the left and remove the screw as shown in the illustration.
      Fig 2: Locating Steering Wheel Assembly Screw (LEFT)
      GTY208085Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Disengage the 2 claws and remove the lower steering column cover.
      Fig 3: Identifying Lower Steering Column Cover And Claws
      GTY208081Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Disengage the claw and remove the upper steering column cover.
      Fig 4: Identifying Upper Steering Column Cover And Claw
      GTY208080Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY 
    1. Disconnect the 2 connectors.
      Fig 5: Locating Windshield Wiper Switch Assembly And Claw
      GTY208082Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the claw and remove the windshield wiper switch assembly.
      NOTE:

      If the claw is pushed with excessive force, it may break.