Rear Wiper Rubber: Installation: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL REAR WIPER RUBBER
1. Install the rear wiper rubber backing plates as shown in the illustration.
  
  Fig 1: Identifying Rear Wiper Rubber Backing Plates
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  NOTE:
  Install the backing plates facing the correct direction.
2. Insert the wiper rubber from the front end of the wiper blade to the rear end through the second claw.
3. After pushing the wiper rubber through the rear end claw, allow it to stick out from the rear end stopper.
  
  Fig 2: Pushing Wiper Rubber Rear End Claw From Rear End Stopper
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Slide the wiper rubber through the front end claw.
  
  Fig 3: Sliding Wiper Rubber Through Front End Claw
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR WIPER BLADE ASSEMBLY
1. Push the wiper blade straight toward the right side of the vehicle to install it to the wiper arm.
  
  Fig 4: Identifying Rear Wiper Blade Assembly Claw
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  NOTE:
  Be careful not to damage the claw.
2. Connect the rear wiper head cap.
  
  Fig 5: Identifying Rear Wiper Arm Head Cap
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002